I'm away from my computer, so this will be brief. avoid-slur does not work on a tie because a tie is not a slur. Can you typeset it as a slur? Seems like one, since you're asking them to behave as tw
That's the best part about Lilypond, isn't it? :) I've seen this page before. I'll have to take a stab at it sometime. I'm heading to bed right now, and I'll work on this music tomorrow at some point
Am 21.06.2011 16:16, schrieb Janek Warchoł: I agree. This would be what I'd like to see. Would your syntax express one slur (g' to a') or two slurs (g' to a' and e'' to d'')? What would happen in th
Mus Felix wrote Sunday, April 17, 2011 9:25 PM I have fiddled around with the settings some more and achieved better results, but the slurs still needed manual adjusting. Is there some way to make li
Hello list, hello MusFelix, Perhaps this is a polyphonic problem? With \version "2.12.2" I get Your wanted result with \override Staff.Slur #'details #'steeper-slope-factor = #0 \override Staff.Slur
Jonathan The problem is that acciaccatura and appoggiatura are both slurred to the following note, and slurs cannot be nested. If you change the \acciaccatura to \grace (which isn't slurred to the fo
This is variation of a known problem, namely that you cannot have more than a single slur simultaneously and that the \acciaccatura draws a normal slur. If you want a slur that passes an \acciaccatur
Am Freitag, 26. Dezember 2008 14:33:11 schrieb Jonathan Kulp: Apparently, it reserves space for the natural below the slur, but still places the natural above the slur. Looks like a bug to me... the
But the the attachment-offset does work. Thanks a lot! OK, then you could try the next property in the list: \override Slur #'attachment-offset = #'((0 . -.5) 0 . -.5) If you do: \relative c'''{a8 b
Me too. Speaking as a violin player I do not know what you are referring to. Can you post a picture? Andrew Hello – I’m looking at creating a new slur to be used as a “bowing-slur.” Essential
Le 05/06/2021 à 01:44, Knute Snortum a écrit : Hi all, I am trying to engrave a turn with a flat above it, all under a slur. I can't seem to get it no matter what I try. Here is a fairly minimal ex
That's perfect Jean, thanks! I did fool around with outside-staff-priority, but always with a number. I didn't know it could take a value of false. To the list again, in the Internals Reference for T
Le 05/06/2021 à 01:44, Knute Snortum a écrit : Hi all, I am trying to engrave a turn with a flat above it, all under a slur. I can't seem to get it no matter what I try. Here is a fairly minimal e