I'd like to ask what the minimum hardware configuration is for successful programming of an Atmega32 PDIP chip with Avrdude. I have ordered hardware accordingly. Perhaps this list could kindly be reviewed?
1. Breadboard
2. Atmega32 PDIP
3. 5v power supply
or
An Arduino already configured as a programmer
5. XTAL or resonator of a frequency listed in datasheet
6. If XTAL is used, 22 pf ceramic capacitors
7. LED for a basic blinking light action
8. 330 Ohm and 10K Ohm resistors
9. Possibly a powered USB hub to connect programmer to
Hardware connections as follows:
1. 5v VCC connected to pins 9, 10, 30
2. GND connected to pins 11, 31