[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [avr-gcc-list] Using AVR Studio with avr-gcc

From: Uccelli Danilo
Subject: RE: [avr-gcc-list] Using AVR Studio with avr-gcc
Date: Thu, 1 Jul 2004 17:02:47 +0200

> -----Original Message-----
> From: Douglas Dotson [mailto:address@hidden
> Sent: Thursday, July 01, 2004 3:28 PM
> To: address@hidden
> Subject: [avr-gcc-list] Using AVR Studio with avr-gcc
> Is it possible to take avr-gcc generated code and
> use it in AVRStudio in symbolic mode. I can load
> a program but all I get is dissassembled code. WOuld
> be nice to see the source code.
> Doug

Under Windows98SE,
I use now AVRStudio 4.08 and standard distributed GCC make (20040404) to
build EXTCOFF, I load the .COF file into Atmel AVRJTAG and I debug in C
source without any trouble. (microcontroler ATmega64)

But on early AVRStudio versions I had experimented the same kind of behavior
as you.
The same kind of problems arise debugging some programms not located on
address 0 (special bootstraps).


reply via email to

[Prev in Thread] Current Thread [Next in Thread]