bug#22277: 'dd' - stats are not what expected

[Mike Fiedler]

 

Hi,

 

I ran one of my favorite utilities 'dd' again this evening, this time with bs=1G ( IEC ) - I usually do 1M but this time I dealt with more data to be copied...

I had to copy about 215 GiB of data from one to another drive ( offset 215 GiB was about the end of the last partition ).

So I did:

 

$  dd if=/dev/sdb of=/dev/sda bs=1G count=222
222+0 records in
222+0 records out
238370684928 bytes (238 GB) copied, 1275.03 s, 187 MB/s

When it finished, I got a bit confused, and I asked myself a question if the data I requested did really get copied..  of course it did, but I was not expecting 238 GB to be shown.

To make sure I calculated the 512 byte sector end number out of the 238370684928 bytes 'dd' result and compared it with the output of fdisk showing the last sector of the last partition... I was fine.

 

I think, and many others have a same opinion, 1kB = 1000B, etc, should be banned from use in the IT world, and banned from use by the sales people.

 

The point is, as you probably noticed, if dd is told to use IEC, let's stick to IEC and not get the results in whatever artificial decimal crap....

It can not only confuse, but utility like 'dd' should be 100% specific about handling the units, and there should be not a bit of doubt when it spits out the results.

If I would use 1K in this case, I would not notice the difference - my brain is simply too simple, and small, but 1G should at least result in displaying 222 GiB and for sure not GB.

 

Thank you GNU for coreutils, and for opening the windows to the world.

 

When I die, I will rest with a "GNU/Linux for dummies" book on my heart.

 

 

Sincerely.

 

Mike Fiedler