[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Problem running libtool 1.5 tests
From: |
William Aiken |
Subject: |
Re: Problem running libtool 1.5 tests |
Date: |
Wed, 29 Aug 2007 15:25:37 -0400 |
User-agent: |
Mozilla/5.0 (X11; U; SunOS sun4u; en-US; rv:1.7) Gecko/20060727 |
Ralf,
libtool --version outputs:
ltmain.sh (GNU libtool) 1.5 (1.1220 2003/04/05 19:32:58)
...
so I am running the older 1.5 version.
This is the demo-make.test that is run after the demo-nopic.test
I used your gmake command below and get the same result, with a lot
intermediate output.
I will download,build,install newer m4 and libtool and try again.
Thanks for your help!
Bill
Ralf Wildenhues wrote On 08/29/07 15:10,:
> Hello Bill,
>
> * William Aiken wrote on Wed, Aug 29, 2007 at 08:34:43PM CEST:
>
>> I am trying to build libtool-1.5 on a Solaris 10 x64 (AMD) system
>>using gmake and Sun Studio 12. I downloaded, built and installed m4
>>(m4-1.4.4) and autoconf (2.60) before building libtool.
>
>
> Is that really libtool-1.5 and not libtool-1.5.24? Because the former
> is rather old, more than four years (and I think the quote test has seen
> a related bugfix since). Also, you should be using a newer m4, as 1.4.5
> fixes a rather nasty bug that shows in some Autoconf-generated configure
> scripts.
>
>
>>make runs without error messages.
>>make check fails demo-make.test and quote.test and outputs this at the end:
>>====================================
>>2 of 104 tests failed
>>(1 tests were not run)
>
>
> Thanks. Is that the demo-make.test that is run after demo-nopic.test?
> If yes, then please rerun verbosely like this:
>
> gmake check VERBOSE=yes TESTS="demo-nopic.test demo-make.test quote.test"
>
> and post the output.
>
> Cheers,
> Ralf
--
William Aiken Sun Microsystems, Inc.
Phone: 781.442.3312 ISV Engineering
FAX: 781.442.1520 One Network Drive UBUR01-204
Burlington, Massachusetts 01803