are running the USRP examples on USRP board fsk_tx.py
and fsk_rx.py on one PC. During execution we are receiving too much of noise, what might be the reason?.any solution?
we run both fsk_tx.py and fsk_rx.py simultaneously on
the same PC or do we need to run them on two different PC’s ?
running nbfm_ptt_quick_and_dirty.py we are receiving lot of noise. Please
provide some solution?
4) As suggested in the USRP document, we are using the antenna with following specifications:
1. Electrical Characteristics:
Operating Frequency 2.4~2.5 & 4.9 & 5.15~5.35 & 5.725~5.85 GHz
Type : Linear
of Radiation: Toroidal
2.0 dBi Typical For 2 G 4.0 dBi
Typical For 5 G
Impedance: 50 Ohm nominal
2. Mechanical Characteristics
Swivel : 90 degrees
Thanks and Regards,