I am struggling at the moment to get the USB to my USRP board working again. When I try to run any programs, it returns with
usrp: failed to find usrp[0]
My dmesg output looks like this when I connect my USRP:
usb 3-2: new high speed USB device using ehci_hcd and address 6 usb 3-2: unable to read config index 0 descriptor/all usb 3-2: can't read configurations, error -71 usb 3-2: new high speed USB device using ehci_hcd and address 7 usb 3-2: device not accepting address 7, error -71 usb 3-2: new high speed USB device using ehci_hcd and address 8 usb 3-2: unable to read config index 0 descriptor/all usb 3-2: can't read configurations, error -75 usb 3-2: new high speed USB device using ehci_hcd and address 9 usb 3-2: device descriptor read/8, error -71 usb 3-2: device descriptor read/8, error -71 usb 3-2: new high speed USB device using ehci_hcd and address 10 usb 3-2: unable to read config index 0
descriptor/all usb 3-2: can't read configurations, error -71 usb 3-2: new high speed USB device using ehci_hcd and address 11 usb 3-2: device descriptor read/all, error -71 usb 3-2: new high speed USB device using ehci_hcd and address 12 usb 3-2: can't set config #1, error -71
I don't understand what is happening, because it was happily working not too long ago. I am using the 2.6.15-1-686 kernel. I have no problems mounting my flash drive using the same ports. Also, I can load the firmware via the USB1.1 ports, so I don't think there is anything wrong with the USRP. I am not that familiar with Linux, and I am really stuck at the moment. Any help would be greatly appreciated.
Regards
Lance
Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2ยข/min or less.