I have downloaded and built the GNU
radio source code release 3.0 (Minimal Build) on cygwin. The installation went
without any error. But when i tried to run the sample dial_tone.py, i didnt get
any error but at the same time there was no dial tone sound at the output. So i
checked that the "WAVE" source was enabled in the audio control panel as
instructed, but still no output came.
Earlier when i was installing the wxpython
module as stated in the page and all the steps went well, but when i
tried to run the demo.py as indicated in the 13th step, I didnt get the output
and no error was reported. I feel these two issues have a link and hence i tried
the steps once again, but then got the same problem again.....No Output and No
error... Where could the problem be??
Followed the steps as
Mr. Don Ward had instructed...these include
>When you run
dial_tone.py, does it come back with a prompt or does it hang until you type
Yes, after running the program it immediately comes back to the prompt and does
not hang even for a moment.
>Does your pc play sounds
when you log on, log off, or click on a link?
Yes, The PC plays sounds normally and i dont see any problem
Tried the manual
sampling rate setting option but still the same thing happened....no