Hi,
I have the TV_RX board in slot B and Basic RX in slot A of
the USRP. I am trying to get the raw A/D data that comes into the FPGA, out on
the daughter card connector. I would like to use the 16-bit general purpose debug
pins from the FPGA on the connector on Basic RX. However, I’d like to be
careful before I write to the direction register using the _write_oe given that
an improper setting can cause damage. My question is whether I can have both
TV_RX and Basic RX boards plugged in, while I use the _write_oe? If yes, what
is the precaution that I have to follow? Any suggestions appreciated.
Thanks,
Nirali Patel