discuss-gnuradio
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Discuss-gnuradio] Still not working with 2 DBSRX... :(


From: Jared Jensen
Subject: RE: [Discuss-gnuradio] Still not working with 2 DBSRX... :(
Date: Wed, 24 Oct 2007 15:37:33 -0400

HA!  REFCLK_REG = 43 for RXB, and 41 for RXA.  I had hard-coded 41.  Thank you!  I had looked at db_base.py a long time ago when I got one board working, but I completely forgot about it until your e-mail.  Thanks a lot.  Now the data looks good.  :D  I'll tell our accountant to send you a consulting check.  ;)

Jared

> Date: Wed, 24 Oct 2007 12:21:28 -0700
> From: address@hidden
> To: address@hidden
> CC: address@hidden
> Subject: Re: [Discuss-gnuradio] Still not working with 2 DBSRX... :(
>
> On Wed, Oct 24, 2007 at 12:16:53PM -0700, Eric Blossom wrote:
> > On Wed, Oct 24, 2007 at 02:29:31PM -0400, Jared Jensen wrote:
> >
> > > I'm brainstorming and I wonder if I setup RXB correctly, but haven't
> > > sent some command to gate the data through. Or if there is an
> > > additional step when using 2 channels that isn't documented. Any
> > > ideas of things I could look at?
> >
> > No magic that isn't contained in db_dbs_rx.py
> >
>
> You're looked at the code in db_base.py too, right?
>
> Eric


Help yourself to FREE treats served up daily at the Messenger Café. Stop by today!

reply via email to

[Prev in Thread] Current Thread [Next in Thread]