[Discuss-gnuradio] FSK with RFX2400

[kaleem ahmad]

Hi everyone,

I am trying to implement simple FSK system with USRP and I am using two
USRP's each with one RFX2400 daughter card. I have tried fsx_tx.py and
fsk_rx.py which are available in gnuradio_examples folder. after using tune
to set the proper ferquency I was able to run transmitter and receiver
sussfully. I didnt change anything else in the example. The problem is data
which I receive is too much corrupt (lot of data errors). Can any one
suggest what can be the errors or problems and what can I do to get correct
data.

Secondally how can I remove the ISM bandpass filter which is by default
there with RFX2400.

I am thankful in advance.

Kaleem Ahmad
-- 
View this message in context: 
http://www.nabble.com/FSK-with-RFX2400-tp18587205p18587205.html
Sent from the GnuRadio mailing list archive at Nabble.com.