[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] usrp_wfm_rcv.py failed to set initial frequency e
From: |
Brian Padalino |
Subject: |
Re: [Discuss-gnuradio] usrp_wfm_rcv.py failed to set initial frequency error |
Date: |
Fri, 8 Aug 2008 09:19:14 -0400 |
On Fri, Aug 8, 2008 at 9:15 AM, Halil Yigit <address@hidden> wrote:
> Hi
>
> I'm new to the GNURadio, so I'm trying to get some of the
> basic tests. I am using Flex 2400 daughterboard
This is important later on ...
> I've run the dial_tone.py example, and it is running. for usrp, I have
> tested usrp_wfm_rcv.py. I've connected daughterboard to RXB and TXB.
> Then I write ./usrp_wfm_rcv.py -f 96.5M, I get an error message as follows
> 1. FYI: No powermate or Contour Knob
> 2. Failed to set initial frequency (on USRP WFM RX screen)
> 3. (python 6931): GnomePrintCupsPlugin-WARNING **: The CPUS
> printer couldnt be created
... as it seems you're trying to tune a Flex 2400 to 96.5MHz.
You need to either:
- Tune to a frequency the Flex 2400 can tune
- Acquire a board that can tune to the frequency of interest (96.5MHz)
Brian