[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Re: RFX2400 Transmit Receive question
From: |
Jason Uher |
Subject: |
Re: [Discuss-gnuradio] Re: RFX2400 Transmit Receive question |
Date: |
Fri, 29 Aug 2008 08:48:17 -0500 |
> For TDMA schemes, it would be very nice to know the delay of the AD/DA
> converters (and filters ...), and easiest would to measure the signal from
> the tx port fed back to the same daughterboard via loopback cable to the rx2.
> As far as I understand, this is not possible. (All this requires the
> timestamps of the inband signaling, of course).
>
> Would using a second daughterboards rx require a MIMO/modified daughterboard,
> or is it ok to use two non-MIMO rfx2400 on the same USRP? In my case,
> accuracy of about a few samples would be ok, but there might be other cases
> which require higher accuracy.
Stefan,
The post really didn't have anything to do with MIMO, it was more
about whether the RFX cards were full duplex or not,
I see now that Matt sent the reply to me, not to the list, so here is
what he said:
From: Matt Ettus
>
>Jason Uher wrote:
>>
>> Is it possible to simultaneously transmit through 'TX/RX' and receive
>> on 'RX2' of a single RFX board?
>
>
>
>No.
>
>
>Matt