[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [Discuss-gnuradio] USRP2 with FLEXRF2400 db
From: |
Matigakis Emmanouil |
Subject: |
RE: [Discuss-gnuradio] USRP2 with FLEXRF2400 db |
Date: |
Thu, 27 Nov 2008 13:01:21 +0200 |
Thanks I appreciate your reply. I think I have the same problem with
alliasing but my biggest problem is the gain control. I haven't updated
to the current firmware version yet. I hope it will solve the problem.
Manolis
-----Original Message-----
From: Michael Ossmann [mailto:address@hidden]
Sent: Wed 11/26/2008 9:12 PM
To: Matigakis Emmanouil
Cc: address@hidden
Subject: Re: [Discuss-gnuradio] USRP2 with FLEXRF2400 db
On Wed, Nov 26, 2008 at 11:00:54AM -0500, Michael Ossmann wrote:
>
> I took an acquisition yesterday with usrp2_rx_cfile.py -f 2414e6
> which looks good except that there is aliasing centered at 2412.5
> MHz.
I may have spoken too soon about the aliasing as my results appear
inconsistent. I took two simultaneous (not synchronized)
acquisitions with:
usrp2_rx_cfile.py -s -e eth1 -d 4 -f 2414e6 -g 80 -N 500e6 foo &
usrp2_rx_cfile.py -s -e eth2 -d 4 -f 2414e6 -g 80 -N 500e6 bar &
Each gigabit card was connected directly to a USRP2. Each USRP2 was
running firmware built from rev 10037 and had an RFX2400 installed.
One of the acquisitions exhibits aliasing, but the other does not.
I will try to repeat this next week and see if I made a mistake
somewhere.