[Discuss-gnuradio] USRP2 - 25MS/s

[Douglas Geiger]

 Question about the USRP2 - I just received my order earlier this week,
and got them up and running with no problems.  However, I have a
question about the transfer rate out of them. When I run usrp2_fft.py,
or usrp2_rx_cfile.py I am able to get 25MS/s out of them (using -d 4)
with few or no S's. However, now that I'm playing around with looking at
802.11b packets, and trying to use the USRP2 with the (modified for
hier_block2) BBN code, I cannot run it at that rate without filling the
screen with S's. I can imagine the BBN codeis more cpu intensive than
writing to the file, but does it make sense that usrp2_fft.py has no
problem? Any suggestions on where to start looking for possible bottlenecks?
 I am able to get some results with -d 8 (i.e. 12.5MS/s), however all
the packets I'm receiving have CRC errors (the transmitter is only ~3 ft
away). In case it helps, I'm running on a Core2 Duo @ 2Ghz.

-- 
Doug Geiger
Research Assistant
Communications and Signal Processing Lab
Oklahoma State University
http://cspl.okstate.edu
address@hidden
address@hidden