Re: [Discuss-gnuradio] Failed to set initial freq

[w w]

So, the board is probally bad....can you recommend a good example script for testing purposes?   I also need the the TVRX board to Recieve bi-phase L encoded data....is this possible?

 

Thanks

 

On Wed, Jan 21, 2009 at 2:53 PM, Eric Blossom <address@hidden> wrote:

On Wed, Jan 21, 2009 at 01:55:32PM -0500, w w wrote:
> Greetings,
> I got the TVRX because I need a board to RX AM from 100 to 600 MHZ.   I know
> it is for TV but I thought it could do AM as well.   However I can't seem to
> set the intial freq for the board.   Using the same python script I can set
> the freq for a basic RX board.  I don't seem to see any other errors other
> that then "Failed to set the intial freq".   Any suggestions?   Can the TVRX
> board do AM?
>
> Thanks

The TVRX board covers from 50MHz to about 860 MHz.
It doesn't care what the modulation is.

Eric