Re: [Discuss-gnuradio] Sending a Sinusoidal Signal

[dbeken]

I did set the amplitude in the signal source to 0.001. But still i don´t get
a smooth output signal.

http://www.nabble.com/file/p22536861/saturation.jpg 

What may be the problem in sampling rates, interpolations, decimations.

Thanks 

Dincer



Henry Hallam-2 wrote:
> 
> Hi dbeken,
> I'm very much a radio newbie and don't even have a USRP yet, so take
> this with a pinch of salt.
> It looks like your signal is saturating the receiver, i.e. the output
> power is too high.  Try putting an attenuator inline - maybe start
> with 40dB or so?  Can you turn down the TX power and see if that
> helps?
> 
> Good luck,
> 
> Henry
> 
> 
> 
> On Mon, Mar 16, 2009 at 10:58 AM, dbeken <address@hidden> wrote:
>>
>> To give more detail,
>>
>> even in the following simple configuration i cannot receive the exact
>> signal
>> I am sending. I am very new to USRP2 and SDR.
>>
>> My simplified system:
>>
>> http://www.nabble.com/file/p22535780/loop_test.grc.jpg
>>
>> My TX graph:
>>
>> http://www.nabble.com/file/p22535780/graphTx.jpg
>>
>> and finally what I receive:
>>
>> http://www.nabble.com/file/p22535780/graphRX.jpg
>> --
>> View this message in context:
>> http://www.nabble.com/Sending-a-Sinusoidal-Signal-tp22535722p22535780.html
>> Sent from the GnuRadio mailing list archive at Nabble.com.
>>
>>
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> address@hidden
>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>
> 
> 
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
> 
> 

-- 
View this message in context: 
http://www.nabble.com/Sending-a-Sinusoidal-Signal-tp22535722p22536861.html
Sent from the GnuRadio mailing list archive at Nabble.com.