[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] regarding gnuradio-3.2rc0.tar.gz installation onw

From: Don Ward
Subject: Re: [Discuss-gnuradio] regarding gnuradio-3.2rc0.tar.gz installation onwindows XP
Date: Mon, 4 May 2009 07:54:53 -0400

john boon wrote:

i have been following the mails and going through mail lists, couldnt
find any information which can point me whether installation of
gnuradio-3.2rc0.tar.gz is possible on windows XP.

I have installed 3.2rc2 on Windows XP using Cygwin. The instructions in the wiki should be very close to accurate, with only minor tweaks needed when the 3.2 release is finalized. I did not build the usrp2, comedi, sdl, or qtgui modules. The inband code does not link properly on Cygwin, but this does not stop the build of the rest of the code.

gnuradio-3.2rc2 does not build on MinGW because of the new requirement for an aligned malloc() function. I expect this will be fixed, or you can work around it. Again, I think the instructions in the wiki are pretty close.

i have been successfull in installing gnuradio-3.2rc0.tar.gz on FEDORA 10
and subsequently i tried on windows XP, where it threw results of
successfull configuration of usrp and few components and not the required
gr-usrp,gr-utils,usrp2 and other main components. Whereas with same boost
instlation of version 38, i was able to install gnuradio-3.1.3.tar.gz.

in brief, successfull installation of gnuradio-3.1.3.tar.gz possible on
windows XP not the gnuradio-3.2rc0.tar.gz.

My question based on the above results.

1. can gnuradio-3.2rc0.tar.gz be installed on the windows. has anyone tried
in this regard and succeeded ??

Yes and yes, with Cygwin, and it should be possible in time (or with more work) on MinGW. I have no information on other build environments.

-- Don W.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]