[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Help on GRC to transmit at a specific frequency and w
[Discuss-gnuradio] Help on GRC to transmit at a specific frequency and width
Fri, 28 Aug 2009 12:10:12 +0200
Thunderbird 184.108.40.206 (X11/20090608)
Hi @ all
Sorry, this stuff is new for me and therfore sorry for a possible stupid
question ;-) . I play a little with GRC and want to transmit e.g. a
cosine-wave at a specific frequency e.g. at 900MHz and width, say 2MHz.
But my problem are as following:
If i add only 2 blocks, i got nice constant transmission but the width
are too large, say more than +- 30 Mhz
| signal | | | source:
sample_rate: 1M, waveform:cosine, Frequency: 1k, Amplitude: 100
| source |--------->| usrp2 sink | usrp2 sink:
interpolation: 64, Frequency: 900 MHz, Gain: 0
Is it possible to add a filter between the singal source and the usrp2
sink, maybe the band pass filter? Or is ist only possible with a
hardware filter behind the ursp2?
In case of the band pass filter: which values are right? I tried:
decimation=1, gain=1, samplerate=200k, lowcut=200k, highcut=200k,
transition width=200k. Or shoud the low- und highcut equals to the
frequency at 900 MHz and therfore a samplerate of 1.8 GHz?
I played a while with various values but without success.
thanks in advance
- [Discuss-gnuradio] Help on GRC to transmit at a specific frequency and width,