[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Re: Valve Problem
From: |
Umair Naeem |
Subject: |
[Discuss-gnuradio] Re: Valve Problem |
Date: |
Mon, 10 May 2010 07:31:27 +0000 |
I tried with throotle block before Valve but same thing happens, flow graph
seems to stop working. I think the problem is with Probe Avf Mag^2 block
because when i removed this block the valve start working. Now a new thing
happens, whenever I make it open using a variable during execution, the scope
stops but when I re-enable (close) the valve again an error occurs that is,
usrp2::rx_samples() failed
usrp2: channel 0 not receiving
THere is one more problem when i try to run any flow graph in 64-bit machine.
When I enable "Realtime Scheduling" to ON or when I try to change USRP2 source
frequency or decimation value during execution (using a variable) the error
occurs
Failed to enable Realtime Scheduling
Regards,
Umair Naeem
MSc Communication Engineering
Chalmers University ot Technology, Sweden.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Discuss-gnuradio] Re: Valve Problem,
Umair Naeem <=