Re: [Discuss-gnuradio] EEPROM warning USRP & WBX0510

[santana burintramart]

Hi Matt,

I tried running ./usrp_nbfm_ptt.py -f 149.225e6 , the scope was
running, but the warning messages still show up as follows:

Warning: Treating daughterboard with invalid EEPROM contents as if it
were a "Basic Tx."
Warning: This is almost certainly wrong...  Use appropriate
burn-*-eeprom utility.

audio_alsa_source[hw:0,0]: unable to support sampling rate 32000
  card requested 44100 instead.
>>> gr_fir_fff: using SSE
TX using Unknown (0x0052)

Warning: Treating daughterboard with invalid EEPROM contents as if it
were a "Basic Rx."
Warning: This is almost certainly wrong...  Use appropriate
burn-*-eeprom utility.

RX using Unknown (0x0053)

Do I need to do anything with eeprom?




On Fri, Jun 4, 2010 at 4:45 PM, Matt Ettus <address@hidden> wrote:
> On 06/04/2010 02:35 AM, santana burintramart wrote:
>>
>> Hi,
>>
>> I have a USRP board with 2 WBX0510 daughter boards. When I ran
>> ./usrp_benchmark_usb.py, there were warning messages as follows:
>>
>> Testing 2MB/sec...
>> Warning: Treating daughterboard with invalid EEPROM contents as if it
>> were a "Basic Tx."
>> Warning: This is almost certainly wrong...  Use appropriate
>> burn-*-eeprom utility.
>>
>> Warning: Treating daughterboard with invalid EEPROM contents as if it
>> were a "Basic Rx."
>> Warning: This is almost certainly wrong...  Use appropriate
>> burn-*-eeprom utility.
>>
>> Can anyone suggest me how to resolve this issue?
>
>
> Yes.  Don't run that program.  It doesn't do anything you need.  It was
> written years ago to aid in development of the USB interface, and it is
> outdated.  The real applications all work fine.
>
> Matt
>