[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] UHD USRP2 full duplex mystery solved

From: George Nychis
Subject: Re: [Discuss-gnuradio] UHD USRP2 full duplex mystery solved
Date: Thu, 23 Sep 2010 03:16:39 -0400

To elaborate more on my issue... I see the USRP2 send mac pause frames, and then no new data is sent over the interface for 5-10 seconds.

On Thu, Sep 23, 2010 at 2:46 AM, George Nychis <address@hidden> wrote:
Just saw this thread now... I'm seeing this problem with my USRP2s and the WBX board.  However, I'm not using UHD.  Do you know a fix for this outside of UHD?

On Tue, Sep 14, 2010 at 5:28 PM, Josh Blum <address@hidden> wrote:
FYI - in the future this will go away in the future when tx flow control becomes host-based (and away from ethernet pause frames). -Josh

On 09/14/2010 01:56 PM, Marc Epard wrote:
I've been attempting to do a full duplex send/recv using UHD on a USRP2 with an XCVR2450.

The major problem I had was that issue_stream_cmd nearly always resulted in a runtime error of "usrp2 no control response". It worked fine if I transmitted w/o receiving or received w/o transmitting. The same code also worked when using a 2nd USRP2 for receiving.

After a session with Wireshark and the UHD host source, I had my "Well, duh" moment. When you call send, the data starts streaming to the USRP2 right away -- even if you specify a timestamp in the future. The USRP2 starts sending back PAUSE frames almost immediately, which throttles not only additional send data, but also any commands to the control port.

The solution is to call issue_stream_cmd first (and start the recv thread), then start the send thread. This was simple enough in my app because I was specifying start times in the future anyway. It does prevent a method I was going to use on a WBX where I start the send thread once and scan through several receive frequencies before stoping the send thread.

Perhaps most of you knew about this gotcha already, but I hope this will help someone else who encounters the problem. Anyway, it was fun investigating and I learned a lot more about the UHD host code and protocols


Discuss-gnuradio mailing list

Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]