Re: [Discuss-gnuradio] build error

[Achilleas Anastasopoulos]

Dahhhhhhhhhhhhhhhh!

thanks
Achilleas

On Sun, Oct 24, 2010 at 11:54 AM, Tom Rondeau <address@hidden> wrote:
> On Sun, Oct 24, 2010 at 11:35 AM, Achilleas Anastasopoulos
> <address@hidden> wrote:
>> yes, i can run all the tests in the different example directories.
>>
>> However i cannot find/run  grc
>>
>> Achilleas
>
>
> "grc" was changed a bit back to "gnuradio-companion" because of a
> naming conflict. Is that available?
>
> Tom
>
>
>
>> On Sun, Oct 24, 2010 at 11:08 AM, Tom Rondeau <address@hidden> wrote:
>>> On Sun, Oct 24, 2010 at 10:48 AM, Achilleas Anastasopoulos
>>> <address@hidden> wrote:
>>>> I am trying a new build from the source tree on fedora 12.
>>>> Configure gives the result shown at the end of the email.
>>>> Make and make check complete fine, but sudo make install
>>>> completes with the message:
>>>> *** Post-Install Message ***
>>>> Warning: python could not find the gnuradio module.
>>>> Make sure that /usr/local/lib64/python2.6/site-packages is in your 
>>>> PYTHONPATH
>>>>
>>>> make[3]: Leaving directory `/home/anastas/gnuradio_trunk'
>>>> make[2]: Leaving directory `/home/anastas/gnuradio_trunk'
>>>> make[1]: Leaving directory `/home/anastas/gnuradio_trunk
>>>>
>>>> I know the PYTHONPATH is set appropriately, since I can import gnuradio
>>>> from within python...
>>>
>>> If you can import gnuradio, can you also run GNU Radio applications?
>>> This might be a misunderstanding during the install but not an actual
>>> problem.
>>>
>>> Tom
>>>
>>>
>>>
>>>> Also grc is not installed in /usr/local/bin
>>>>
>>>> Any ideas,
>>>> Achilleas
>>>>
>>>>
>>>>
>>>>
>>>> '*********************************************************************
>>>> The following components were skipped either because you asked not
>>>> to build them or they didn't pass configuration checks:
>>>>
>>>> usrp2-firmware
>>>>
>>>> These components will not be built.
>>>>
>>>>
>>>> *********************************************************************
>>>> The following GNU Radio components have been successfully configured:
>>>>
>>>> config
>>>> gruel
>>>> gnuradio-core
>>>> usrp
>>>> usrp2
>>>> gr-usrp
>>>> gr-usrp2
>>>> gr-msdd6000
>>>> gr-audio-alsa
>>>> gr-audio-oss
>>>> gr-atsc
>>>> gr-cvsd-vocoder
>>>> gr-gpio
>>>> gr-gsm-fr-vocoder
>>>> gr-noaa
>>>> gr-pager
>>>> gr-radar-mono
>>>> gr-radio-astronomy
>>>> gr-trellis
>>>> gr-video-sdl
>>>> gr-wxgui
>>>> gr-qtgui
>>>> gr-sounder
>>>> gr-utils
>>>> gnuradio-examples
>>>> grc
>>>> docs
>>>>
>>>> You my now run the make command to build these components.
>>>>
>>>> *********************************************************************
>>>> The following components were skipped either because you asked not
>>>> to build them or they didn't pass configuration checks:
>>>>
>>>> gcell
>>>> gr-gcell
>>>> gr-audio-jack
>>>> gr-audio-osx
>>>> gr-audio-portaudio
>>>> gr-audio-windows
>>>> gr-comedi
>>>>
>>>> These components will not be built.
>>>>
>>>> Configured GNU Radio release v3.3.1git-92-gdd74b98a for build.
>>>>
>>>> _______________________________________________
>>>> Discuss-gnuradio mailing list
>>>> address@hidden
>>>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>>>
>>>
>>
>