[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Switching of UHD/Raw-Ethernet Driver

From: Bishal Thapa
Subject: Re: [Discuss-gnuradio] Switching of UHD/Raw-Ethernet Driver
Date: Thu, 18 Nov 2010 15:36:36 -0500

2. I am using XCVR2450 with USRP2. I initially just wanted to find out which
antenna (J1 or J2 -- connected to RF2 and RF1 in my USRP2 respectively), was
defined to be RX and which one to be TX? I found out from a file
"db_xcvr2450.cc" that J1 was defined to be RX and J1-TX, however with my
spectrum analyzer I found the contrary to be true. Is there an easy way to
check, and be able to set J1 or J2 to Rx or Tx in Python? I did search the
threads and couldn't find satisfying answer.

It depends how you set the antennas:


Hi Josh,
  Thank you for your answers. For this second answer, I didn't understand your reply. The link you sent does not say anything about how to set the TX/RX to J1/J2. It just says it could be set to either one. My question is, is there a way (API) in python to set this specifically ?

Sorry if I didn't catch something obvious :(.
Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]