---------- Forwarded message ----------
From:
Justin Bracken <address@hidden>Date: Tue, Nov 30, 2010 at 11:35 AM
Subject: USRP2 Lo Frequency Change
To:
address@hidden
Hello All,
As always thanks for the help.
I was doing some timing measurements the other day and was wondering if this seemed reasonable to you all. I did a simple setup in GRC where I had a toggle switch that changed the frequency the usrp used as an LO. I input a constant of 1 into the USRP2 block and then hooked the usrp2 to a highspeed oscilliscope. I used the toggle switch to change the lo frequency back and forth and with the aid of a stopwatch I saw that the change took about 1.2 seconds to take affect. Is 1.2 seconds a reasonable or expected amount of time? Or is this more indicative of something else?
Thanks,
Justin