[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Constant output message source
From: |
ichigo.san |
Subject: |
[Discuss-gnuradio] Constant output message source |
Date: |
Sat, 19 Feb 2011 01:52:14 -0800 (PST) |
Hi,
I was wondering if there is a method to have a source block constantly
sending out "0" and once it recieves a message from python, e.g a packet, it
will then stream the message and switch back to sending "0" when done.
I've tried:
Message Source ----------------------------> (Add, 0)
Constant Source/Vector Source with 0 -----> (Add, 1) ---> output
However, the add block (and all blocks in gnuradio) waits for stream items
from both inputs to be ready (i.e no interpolation) before making a output
stream item. This effectively nullifies the const source in the above
example.
I was wondering if there is any possible way to solve this problem?
The reason I am asking this is I am using a dual TX setup on a single USRP
which interleaves output signals. I have I output signal that is constantly
sending (beacon) and one that is only sending sometimes, however the
interleaving of output signals means that both streams needs to be
constantly sending.
--
View this message in context:
http://old.nabble.com/Constant-output-message-source-tp30964604p30964604.html
Sent from the GnuRadio mailing list archive at Nabble.com.
- [Discuss-gnuradio] Constant output message source,
ichigo.san <=