|
From: | Philip Balister |
Subject: | Re: [Discuss-gnuradio] UHD Driver in E100/Beagleboard |
Date: | Thu, 24 Feb 2011 08:35:24 -0500 |
User-agent: | Mozilla/5.0 (X11; U; Linux x86_64; en-US; rv:1.9.2.13) Gecko/20101209 Fedora/3.1.7-0.35.b3pre.fc14 Thunderbird/3.1.7 |
On 02/23/2011 11:25 PM, Almohanad Fayez wrote:
I was wondering about people's experience with the UHD driver on the E100 or the Beagleboard. I am able to use it to receive IQ data from the USRP but I can't seem to transmit anything from it ... if I take the same flowgraph to a laptop I'm able to transmit IQ using the same USRP/daughterboard and the UHD driver however when I try to run the same transmitter on the Beagleboard and I check my spectrum analyzer I don't see anything
Data comes out of the E100 fine, I assume you have a USRP1 attached to a beagle via USB?
Philip
I already did a signal capture before sending to the USRP and made sure that there is data getting pushed through ... is there a problem with UHD/USRP sinking on the E100 and the Beagleboard ??? I also made sure that I'm using the latest UHD firmware on the beagleboard. The following is the version info printed when I run the flowgraph: linux; GNU C++ version 4.5.3 20110214 (prerelease); Boost_104500; UHD_0001.20110224034946.1 thanks al fayez _______________________________________________ Discuss-gnuradio mailing list address@hidden http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |