Re: [Discuss-gnuradio] multi_usrp

[john]

On Sun, 2011-07-31 at 18:30 -0400, Marcus D. Leech wrote:
> On 07/31/2011 11:14 AM, john wrote:
> > O
> > Thanks Marcus. Yes, that technique is quite useful - particularly in
> > setting up channels, addressing etc. however, in terms of giving the
> > board ID of the RX/TX on either 'side' of a USRP1 it is not so great.
> > Yes, you can readily get frequency range/antenna/gain but I need a bit
> > more.
> >
> >               Kind Regards,
> >
> >                       John
> >
> >
> I'm not fully understanding what it is you need.  You need to *fetch* 
> the board ID from the
>    interface, rather than setting the subdev specifications?
> 

You are correct Marcus in terms of what I want to do. From reading the
comments in the code, I thought that I was to use set_subdev for the
channel(s) and then could both set/get relevant parameters ( freq range,
gain etc. ) i.e. attributes which use channelid as parameter. ( I think
that is how it was described).

I wish to get mboard type and rx and tx dboard types for USRP1 but using
UHD as the dboards are only supported under that paradigm when they were
announced.

 Sorry if I am passing on my confusion,

        Kind Regards,

                    John