[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] UHD + USRP2 + WBX doubt

From: skcruser
Subject: Re: [Discuss-gnuradio] UHD + USRP2 + WBX doubt
Date: Fri, 9 Sep 2011 00:10:45 -0700 (PDT)

sumitstop wrote:
>>> http://www.youtube.com/watch?v=REDK7M-83WQ
> i had seen that video sumit..in tht LED B turns on in the end rite...
> in my case it was not turning on..so i got worried
> now i knw tht it turns on only when mimo cable is being used
>>> uhd_fft.py receives the signal from the specified range and shows its
>>> spectrum... hence led C turns on which that indicates usrp2 is
>>> receiving.
> hmm...it was not turning on when i was using raw ethernet drivers...so the
> concern
> now i guess theres nothing to worry abt...thanx man
> skcruser wrote:
>> I am using the WBX daughterboard with USRP2 interfaced using the UHD
>> Driver.
>> The LED boot sequence is as follows
>> 1. F turns on
>> 2. E, C, A turn on and then blink and turn off
>> 3. D turns on
>> is the above sequence correct? (B never turns on)
>> also when I run uhd_fft.py, led C turns ON. is it normal or shud i be
>> worried?
>> PS - what is the significance of each LED??

View this message in context: 
Sent from the GnuRadio mailing list archive at Nabble.com.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]