Re: [Discuss-gnuradio] OFDM timeout error

[Tom Rondeau]

On Mon, Jul 30, 2012 at 1:11 PM, Ebtisam Ahmed <address@hidden> wrote:
> Hi everybody,
> Im using gnuradio 3.2.2 and usrp rfx2400. when i use benchmark_tx/rx
> example i always get timeout error.......
> i cant figure this out. This is the command i run with the output at a
> receiver...
>
> address@hidden:/home/mimo/ofdm# python benchmark_ofdm_rx.py -f 2452M --log
>>>> gr_fir_ccf: using SSE
>>>> gr_fir_fff: using SSE
> TIMEOUT
>
> Regards,
> Ebtisam

That happens when you get a sync symbol but are not able to decode any
following symbols. It means you have too high of a bit error rate. You
'll need to adjust your gain settings to improve the performance.

Tom