[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Can another DUC chain be added to USRP N210?

From: Josh Blum
Subject: Re: [Discuss-gnuradio] Can another DUC chain be added to USRP N210?
Date: Fri, 28 Sep 2012 15:36:31 -0700
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:15.0) Gecko/20120827 Thunderbird/15.0

On 09/28/2012 08:49 AM, Anisha Gorur wrote:
> Hello All,
> I am using a USRP N210. When i set the subdev spec for my basic RX
> daughterboard as "A:A A:B" I can receive two channels. However, if I try to
> do something similar for the basic TX I get an error like "The user
> specified 2 channels, but there are only 1 tx dsps on mboard 0." I assume
> this is because there is only one DUC chain in the N210. Is there a way to
> modify this so that I can have two DUC chains in the same way that I have
> two DDC chains?
> Thanks,
> Anisha

I think adding two complete DUC chains into N210 would be too
complicated to be worth it.

Is there something specific that you cant do with the single DUC chain?
As long as the cordic is set to zero, I and Q will remain completely
separate from host samples, all the way to the SMA connectors A and B.

Otherwise, perhaps you need a different rotation for I vs Q? I think
that would be better accomplished by two different cordics. Then perhaps
a custom DSP in the FPGA is for you:

I hope that helps.


> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

reply via email to

[Prev in Thread] Current Thread [Next in Thread]