[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] The FPGA build is not compatible with the host co
Re: [Discuss-gnuradio] The FPGA build is not compatible with the host code build
Tue, 14 Apr 2015 11:02:52 -0500
Mozilla/5.0 (X11; Linux x86_64; rv:31.0) Gecko/20100101 Thunderbird/31.6.0
we did update our FPGA images on the N-Series for the next upcoming
release. You will need to update the device according to our manual
(http://files.ettus.com/manual/page_usrp2.html). This change was
necessary (among other things) for the N-Series to support our new UBX
Note that you might have to git pull again -- we didn't properly sync up
code and images release last week, so you might be stuck between the
code change and the images update. After git pulling, run
On 14.04.2015 08:38, cczhengy wrote:
I'm a new user of GNURadio and USRP. I used the script "build-gnuradio" to
download the source and have installed them all.But when I tried the
"uhd_fft", the terminal showed as belows:
Linux; GNU C++ version 4.6.3; Boost_104800; UHD_003.008.002-168-gddae9468
-- Opening a USRP2/N-Series device...
-- Current recv frame size: 1472 bytes
-- Current send frame size: 1472 bytes
Please update the firmware and FPGA images for your device.
See the application notes for USRP2/N-Series for instructions.
Expected FPGA compatibility number 11, but got 10:
The FPGA build is not compatible with the host code build.
I followed the instruction as above. However, the problem still exists. I
noticed that the images it downloaded is
"uhd-images_003.008.002-157-gbe03e694.zip",which seemed to be not compatible
Can anyone tell me how to figure it out ? which of the files on
http://files.ettus.com/binaries/images/ is number 11?
Thanks very much.
View this message in context:
Sent from the GnuRadio mailing list archive at Nabble.com.
Discuss-gnuradio mailing list