On 04/07/2015 06:50 AM, David Halls
You don't need to address the gain elements individually, unless you
have special requirements. UHD will distribute the requested gain
For some experiments I would like to transmit using N210s with
XCVR2450 with maximum transmit gain.
I can see Ettus website that the XCVR2450 board in the transmit path has a gain of:
VGA: 0-30 dB range
BB: 0-5 dB range
Can I just set the gain via GNU Radio/UHD to 35, or do I need
to set these two values individually, and if so how.
I read this thread, but didn't quite follow
NOTE: The information in this email and any attachments may be
confidential and/or legally privileged. This message may be
read, copied and used only by the intended recipient. If you are
not the intended recipient, please destroy this message, delete
any copies held on your system and notify the sender
Toshiba Research Europe Limited, registered in England and Wales
(2519556). Registered Office 208 Cambridge Science Park, Milton
Road, Cambridge CB4 0GZ, England. Web:
This email has been scanned for email related
threats and delivered safely by Mimecast.
For more information please visit http://www.mimecast.com
Discuss-gnuradio mailing list