(This message was also posted on USRP-users mailing list.)
I am trying to connect USRP E100 to my PC, ubuntu 14.04
But I am having a difficulty on finding uhd device.
The followings what I have done til now:
$ sudo ethtool eth0 # check if ethernet is gigabit
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: external
Auto-negotiation: on
Supports Wake-on: g
Wake-on: g
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes
$ ifconfig # check if PC and E100 is in a network
eth0 Link encap:Ethernet HWaddr 00:25:64:c2:16:be
inet addr:192.168.10.1 Bcast:192.168.10.255 Mask:255.255.255.0
inet6 addr: fe80::225:64ff:fec2:16be/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:251 errors:0 dropped:0 overruns:0 frame:0
TX packets:1943 errors:4 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:254997 (254.9 KB) TX bytes:193482 (193.4 KB)
Interrupt:16
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:839 errors:0 dropped:0 overruns:0 frame:0
TX packets:839 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:66205 (66.2 KB) TX bytes:66205 (66.2 KB)
$ uhd_find_devices # check if there is USRP connected
linux; GNU C++ version 4.8.2; Boost_105400; UHD_003.009.git-189-g6b64d9bb
NO UHD Devices Found