Re: [Discuss-gnuradio] Audio bandwidth

[Marcus Müller]

Hi Hoang,

are you sure you want to reduce the FM signal bandwidth to 6kHz in the Low Pass filter?

Best regards,
Marcus

On 10/15/2015 04:38 PM, Hoang Nguyen Tran wrote:

Hi Tom,

Thank for replying, Below is my narrow band fm receiver base on nbfm rx from http://www.oz9aec.net/

I was able to receive and decode with ISS and other sat with 1200 baud rate, but did not success with 9600 baud rate.

On Thu, Oct 15, 2015 at 10:11 AM, Tom Rondeau <address@hidden> wrote:

On Wed, Oct 14, 2015 at 2:47 PM, Hoang Nguyen Tran <address@hidden> wrote:

Hi all,

I have question related to audio bandwidth cutoff.

Yesterday, I received very good signal from STRaND satellite 9600 bps, FSK modulation.

I used audio sink to record the signal then used it for decoding.

However, I was unable to decode signal, then I ask some another ham radio expert and he said because of my audio bandwidth cut off for some unknown reason is 3000 so it is unable to decode.

Do anyone know why and how can I change the audio bandwidth cut off ?

I used the normal WAV file sink with set up: sample rate 48000, N channels : 1 and Bít per sample 16.

Thank for your time and I appreciate any comment.

Best regards,

Hoang

Hoang,

It's nearly impossible to help you here since you've given us no information on your setup. Yes, sample rates and filter bandwidths matter in this. You've likely got some numbers in your flowgraph wrong.

Tom

 

--

 -HoangNT-
PhoneNo :  +841654248782

Skype : hoangastro

FB : https://www.facebook.com/kenshin.rorouni

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio