Re: [Discuss-gnuradio] [spectrum sense bug][usrp]

[Marcus Müller]

Hi Heitor,

if the same applies to you just displaying e.g. 10MHz of bandwidth with uhd_fft, you probably have a hefty oscillator offset, either on the N210 10MHz reference or your signal generator.  What generates your signal, and which LEDs are active on your N210?

Best regards,
Marcus

On 02.03.2016 21:06, Heitor Araujo wrote:

Hi

I'm trying to do a basic spectrum sense with a USRP N210 kit and gnuradio.

I made a literature research and noted that the “usrp_spectrum_sense.py” code was used in some articles. But when transmit some signal in a certain frequecy and execute the “usrp_spectrum_sense.py”, the signal is found by the code, but it appears in another frequency (usually about 1Mhz ahead). And also the bandwidth of the received signal is different from the transmited signal (It seems it depends of the sample rate of the transmited the signal).

sudo ./usrp_spectrum_sense.py 699M 702M --fft 512 and execute the "uhd_tx_dpsk.grc" in gnuradio to transmit the signal from 700.2M tom 700.4M. The signal is detected in 700.7M to 701M.

Thanks

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio