Re: [Discuss-gnuradio] problems with windows binaries and audio

[Achilleas Anastasopoulos]

Thanks Geof,

How exactly can I do what you are suggesting in GRC?

The only available controls on the audio sink is the bit rate and an entry called "audio device".

What exactly should I enter in this entry?

thanks again,

Achilleas

On Sat, Nov 5, 2016 at 4:05 PM, Geof Nieboer <address@hidden> wrote:

Achilleas,

There are several others who had had success, so there must be something unique in your setup .  Do you have more then one audio device installed?  If you do perhaps it is being routed to the wrong audio device.  The default is the windows wave mapper which normally should send it to your default audio device.  You can try specifying the audio device in the block settings.

The audio -source- is not yet implemented but it will be in 3.7.10.2 when released

Geof

On Friday, November 4, 2016, Achilleas Anastasopoulos <address@hidden> wrote:

Hi,

I have installed the windows binaries from GCNDevelopment

http://www.gcndevelopment.com/gnuradio/

A simple test with a wav file and an audio sink does not seem to work.

I have changed the config file to use audio - windows but still this is not working.

(same grc file works fine on Linux).

I have tried this on both Windows 7 and 10 with no success.

Can someone report if they had success with audio on Windows with these binaries?

Any ideas as to what else I can try?

thanks

Achilleas