Are you saying that there are no sync bytes in my stream?
or should i wait until i get byte 0x47 in my udp packet, wait till i get 188 bytes, and send them as an array of bytes in the zeroMQ?
Van: "Ron Economos" <address@hidden>
Aan: "discuss-gnuradio" <address@hidden>
Verzonden: Woensdag 26 april 2017 20:16:10
Onderwerp: Re: [Discuss-gnuradio] WARN: transport stream sync error
The BBheader block expects the Transport Stream to start with a
sync byte (0x47) and that a sync byte appears every 188 bytes.
There's no sync byte synchronization in the BBheader block, so if
the stream doesn't start with a sync byte, you'll get continuous
errors.
Ron
Hi,
My setup:
Linux gnuradio with dvb-s2 tx sample code. adjusted to read
from ZeroMQ pull source
5M symbol. in 8psk dvb-s2 3/4 code rate
Windows side: 2 programs:
1) program to make udpts stream from webcam(5M) -> send
udp stream to 127.0.0.1:1234
2) program to listen to udp port 1234 get udp packets and
send them to ZeroMQ push socket
gnuradio is complaining about transport stream sync error.
What can be the reason for this?
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio