|
From: | Ali |
Subject: | Re: [Discuss-gnuradio] USRP DDC and GNURadio Bandwidth Problem |
Date: | Thu, 17 May 2018 16:10:27 +0300 |
DerekRegards,Hello Ali,To extend what Marcus has said, here is a link to the UHD manual page about sample rates.
http://files.ettus.com/manual/page_general.html#general_ sampleratenotes On Mon, May 14, 2018 at 8:54 AM, Müller, Marcus (CEL) <address@hidden> wrote:Hi Ali,
just like the console will tell you, 25 kS/s is simply impossible with
an X310; instead, the minimum possible rate was used.
You should probably just configure your X310 to get you e.g. 500 kS/s,
and then resample in digital domain. If you're hesitant to design your
own decimating filter, use the "rational resampler" block and configure
it to decimate by (500/25)=20.
Best regards,
Marcus
> ______________________________
On Mon, 2018-05-14 at 10:18 +0300, Ali wrote:
> Hi to all,
>
> I am using GNURadio to control an X310. I want to get IQ samples for only 25 kHz bandwidth.
>
> When I wrote 25 kHz to the bandwidth line in UHD-Source block in GNURadio, I still see the signals at 50 kHz or 75 kHz away from the center. My sampling rate is 195312 Hz. When checked in MATLAB, the signals are there. It looks like I cannot control the bandwidth with GNURadio.
>
> I suspected that there is not any DDC filter for this bandwidth. If it is so, what is the minimum bandwidth for USRPs? Are the bandwidths that I can use discrete? I am confused.
>
> Thanks in advance,
> Ali
>
_________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |