Re: [Discuss-gnuradio] Variable in Delay block

[Ron Economos]

You should also change the Trigger Mode in the QT Time sink to Normal.

Ron

On 05/30/2018 08:05 PM, Ron Economos wrote:

It's just a scaling issue. One sample of delay at 32 ksps is much longer in time than one sample of delay at 10 Msps. Try the following changes.

1) Change the number of points in the QT GUI Time sink to 32768.

2) In the QT GUI range block, change the Stop value to 10000 and the Step value to 100.

Ron

On 05/30/2018 07:39 PM, Yeo Jin Kuang Alvin (IA) wrote:

Hi Ron,

 

Thanks! It works for me too, but when I increase the samp_rate to 10e6, can’t see the delay.

 

 

From: Discuss-gnuradio [mailto:address@hidden] On Behalf Of Ron Economos
Sent: Monday, 28 May 2018 6:08 PM
To: address@hidden
Subject: Re: [Discuss-gnuradio] Variable in Delay block

 

It works here. Here's a small flow graph that I tested the delay block operation with.

http://www.w6rz.net/delay.grc

Ron

On 05/28/2018 02:33 AM, Yeo Jin Kuang Alvin (IA) wrote:

Hi Ron,

 

That means the Delay block is able to change as well, but why do I not see the delay when simulating on the time sink?

 

Thanks in advanced!

 

From: Discuss-gnuradio [mailto:address@hidden] On Behalf Of Ron Economos
Sent: Monday, 28 May 2018 5:26 PM
To: address@hidden
Subject: Re: [Discuss-gnuradio] Variable in Delay block

 

If a block variable can be changed during run time, it will be underlined in the properties dialog. For example, in the Multiply Const block, the variable "Constant" can be changed.

Ron

On 05/28/2018 01:46 AM, Yeo Jin Kuang Alvin (IA) wrote:

Hi all,

 

Is it possible for me to create a QT GUI Range and put the ID in the Delay of the delay block? I tried and the graph doesn’t change.