|
On 07/17/2018 05:01 PM, Justin Shetty
wrote:
No different than when I'm not transmitting.
Relatively flat line around -120dB.
Does that line go up in power proportional to the RX gain setting
(actually, it'll only increase at the highest gain settings
probably).
Also I don't have access to the SA right this
moment so I can't get a screenshot.
On
07/17/2018 04:27 PM, Justin Shetty wrote:
> I'm using the SBX daughter board. I also misspoke, when I
said no
> attenuation I was actually using a 10dB attenuator that I
forgot about.
>
Here's an experiment you can try.
Place a terminator on the RX input that you're using. Do
these spurs go
away? What about at other tuned frequencies?
|