Good morning Sir, I would like to calculate sensitivity of USRPN210 Radio module by using gnuradio tool..I working on that ..I tried lot sir..please help me and please forward .GRC file if u have sensitivity measuring...in specification his given -110dbm but practically I want calculate and how to send -80dbm power to antenna..please guide me sir
Good evening Sir, ..Sir i am working on GNURADIO tool..and i am developing BPSK modulation and i tried SNR calculation in that and i already calculated the SNR value and i want to send that value in to text file,but i could not able to send that value in to file.. please help me sir..please find outthe grc file attached Thanks & Regards,Suresh T,Navstar Integrated Systems Pvt ltd,9866212494
Thankyou. I partially resolved this by uninstalling UHD and GRC, and using the latest PyBOMBS to compile from source both UHD and GRC. The good news is that after installing the correct FPGA image, GRC runs. Unfortunately it is not operating correctly. GRC is throuwing codes Gt, the simple generate a cosine tone, send it to the Ettus X310, then loop it back to the receiver for display seems to only show LO leakage at 0 Hz. Additionally GRC will not properly end, and I must force an exit.
Attached is the console output (text file). It looks like I have some files from the old install that are interfering with the new GRC install. I'm not sure where to look to erase them if so. Any other idea's what is the issue?
On Sunday, September 23, 2018 6:35 PM, Dave NotTelling <address@hidden> wrote:
> John,
>
> The issue you are having is that the version of the firmware on your radio does not match the version of the UHD libraries that you have on your system. You need to either update your radios (uhd_image_loader) or change your version of UHD to match what the radio has. The former is the better choice in my opinion.
>
> I think that you need to add `--init-only` to the uhd_usrp_probe command to tell if the versions line up. I seem to recall not getting the version error without it.
> You likely don't need to install from source. As far as I know gr-uhd just makes use of the system UHD install. Perhaps you have two different locations that UHD is installed to? You could double check that you don't have libuhd.so in /usr/local/lib and /usr/lib at the same time. I'd suggest updating the radios to the current firmware with uhd_image_loader, power cycling them, and then trying again.
>
> Good luck!
>
> -Dave
>
> On Thu, Sep 20, 2018 at 5:36 PM John_w_g <address@hidden> wrote:
>
>> I am using Ubuntu 18.04 and the only listed GRC version in the ppa is version 3.13.0.1
>>
>> I have an Ettus x310 and have downloaded the correct FPGA image and verified correct operation with uhd_usrp_probe.
>>
>> I have GRC 3.7.11 installed and when I attempt to access the x310, I get an incompatible FPGA version.
>>
>> First question is what is the correct GRC version to work with this UHD version?
>>
>> Second question as a relatively new Linux user, I really don't want to compile source code. If that is necessary, where should I look for a detailed description of the correct process.