Re: configure.in support for FreeBSD ia64/sparc64/powerpc

[Dan Nicolaescu]

Ulrich Mueller <address@hidden> writes:

  > >>>>> On Mon, 6 Nov 2006, Giorgos Keramidas wrote:
  > 
  > >On 2006-11-03 22:28, Chong Yidong <address@hidden> wrote:
  > >>Giorgos Keramidas <address@hidden> writes:
  > >>> The following change makes Emacs buildable on FreeBSD running on
  > >>> sparc64, ia64 and powerpc too.  It has been tested for some time
  > >>> as a local patch in the editors/emacs-devel port of FreeBSD, so it
  > >>> would be nice if it became part of Emacs 22.  We won't have to
  > >>> maintain local diffs for this part then:
  > >>>
  > >>> --- a/src/alloc.c       Fri Oct 27 15:45:51 2006 +0000
  > >>> +++ b/src/alloc.c       Sat Oct 28 01:49:45 2006 +0300
  > >>> @@ -4560,7 +4560,11 @@ mark_stack ()
  > >>>       needed on ia64 too.  See mach_dep.c, where it also says inline
  > >>>       assembler doesn't work with relevant proprietary compilers.
  > >>> */
  > >>>  #ifdef sparc
  > >>> +#ifdef __sparc64__
  > >>> +  asm ("flushw");
  > >>> +#else
  > >>>    asm ("ta 3");
  > >>> +#endif
  > >>>  #endif
  > >>
  > >> Is this change correct for non-FreeBSD sparc64 systems too?
  > >> (I don't know anything about this part of the code.)
  > 
  > > Sorry for taking so long to follow up about this.  I tried looking
  > > at the sparc v9 specification for hints about why this change is
  > > needed on 64-bit SPARC platforms, but I couldn't come up with
  > > anything in a reasonable amount of time.  I am not that proficient
  > > with SPARC64 assembly, but I will ask our FreeBSD/sparc64 people for
  > > details.
  > 
  > > I'll follow up again when I get a reply from the people who know more
  > > about sparc64 assembly :)
  > 
  > Following up to this message from two years ago. ;-)
  > 
  > Gentoo also maintains the above as local patch, both for FreeBSD and
  > GNU/Linux. Our Sparc team says that the patch is sane, and without it
  > Emacs cannot be built on Sparc/FreeBSD. See Gentoo Bug 159584 for
  > further details: <http://bugs.gentoo.org/159584>
  > 
  > Below is a slightly updated patch that will apply to the currect CVS
  > trunk. It would be nice if it could make it into Emacs 23.
  > 
  > Ulrich
  > 
  > --- emacs-orig/src/alloc.c
  > +++ emacs/src/alloc.c
  > @@ -4573,7 +4573,11 @@
  >       needed on ia64 too.  See mach_dep.c, where it also says inline
  >       assembler doesn't work with relevant proprietary compilers.  */
  >  #ifdef __sparc__
  > +#ifdef __sparc64__
  > +  asm ("flushw");
  > +#else

Was this tested on GNU/Linux and Solaris (and all other sparc64
platforms)?  Otherwise better make that #ifdef depend on FreeBSD.


  >    asm ("ta 3");
  > +#endif
  >  #endif
  >  
  >    /* Save registers that we need to see on the stack.  We need to see