On Fri, Aug 15, 2008 at 10:42 AM, Michael Allen
<address@hidden> wrote:
Hi,
I recently built a newer ubuntu server and started gnump3d (v
3.0) up on it.
It was working fine for a few weeks, until today, when I
attempted to include an IP in the allowed_clients = list.
(appending a semicolon and the ip to the current list).
I backed out that change and set it back to only allow my
local network ips in:
allowed_clients = 192.168.1.0/8
I may well have screwed up the configuration file, but can't
get it working again. The odd thing is that it even has a
process id (see below).
Using the older config file results in the same behavior.
I run a restart of the daemon and it indicates that it wasn't
running in the first place:
$sudo /etc/init.d/gnump3d restart
Restarting gnump3d: start-stop-daemon: warning: failed to
kill 17689: No such process
gnump3d.
I can confirm that it didn't start with this bit of bash
(which returns no results):
$ps -A|grep gnump3d
If I run just a start, i get this output, but again gnump3d
doesn't actually start:
$sudo /etc/init.d/gnump3d start
Starting gnump3d: gnump3d.
Any help would be greatly appreciated