Re: Initial boot problem with cdrom

[Evgeny Stukalov]

Problem solved,

Just for the record, it turned out that the offending
cdrom drive was factory-set to "cable select" mode. 
After setting it to "master" I was able to boot
gnumach normally.

--- Evgeny Stukalov <dazhdbog@yahoo.com> wrote:
> Hi!
> 
> I've run into a problem while trying to
> cross-install
> the Hurd. The initial GNUMach boot stops in midway. 
> I've checked that no shared irq's are in use, 
> and that block size for the Hurd partition is set
> correctly.  After checking the archives 
> of this list and the debian-hurd mailing list I
> recompiled the latest release of gnumach
> (gnumach-1.3.tar.gz from ftp.gnu.org) with only bare
> essentials included (with --enable-ide as the only
> driver option), but booting the new gnumach gave the
> same results.  Here are the boot lines:
> 
> .
> .
> AT386 boot: physical memory from 0x0 to 0x9c00000
> pci bios_init: BIOS32 Service Directory structure at
> 0x 000f7640
> pci bios_init: BIOS32 Service Directory structure
> entry at 0xfd7c0
> pci bios_init: PCI BIOS revision 2.10 entry at
> 0xfd9d4
> Probing PCI hardware.
> hd0: ST34323A, 4112MB w/128kB cache, CHS=557/240/63
> hd1: Compaq CRD-8322B, ATAPI CDROM drive
> ide0 at 0x1f0 - 0x1f7, 0x3f6 on irq 14
> 
> After that it just sits there indefinitely, until a
> key is pressed, which results in kernel panic, or
> till
> I power-reboot.
> 
> What seems strange to me, is that Mach boots just
> fine
> when the cdrom drive is removed.  According to the
> boot messages that Mach correctly identified the
> cdrom
> drive (which is indeed CRD-8322B), so I wonder what
> else is there to try to make it boot normally
> (besides
> unplugging the ide cable from the cdrom drive for
> good).
> 
> Any insights or pointers are very appreciated. And
> let
> me know if any additional info may be helpful.

__________________________________________________
Do You Yahoo!?
Yahoo! - Official partner of 2002 FIFA World Cup
http://fifaworldcup.yahoo.com