Help wanted to boot Hurd-J2

[Gerardo Pirla Diaz]

Hi to all !!!

I've just installed Hurd-J2 on hdb2 (file system created with mke2fs -o 
hurd /dev/hdb2)
All work fine, I've changed /boot/grub/grub.conf and added:

   Title GNU Hird
   root (hd1,1)
   kernel /boot/gnumach.gz -s root=device:hd1s2
   module /hurd/ext2fs.static
   --multiboot-command-line=${kernel-command-line}
   --host-priv-port=${host-port} --host-master-port=${device-port}
   --exec-server-task=${exec-task} -T typed ${root} ${task-create}
   ${task-resume}
   module /lib/ld.so.1 /hurd/exec $(exec-task=task-create)

After this, I've rebooted & selected "GNU Hurd" in the Grub's select 
panel. Apears about 6 lines from grub (the module directives), ... stops 
for a while (about 3 seconds) and the computer reboots .....

The hardware is:

   Athlon XP 1600+
   Via VT Chipset
   GeForce4 TI 4200 (rev 163)
   Pinnacle PCTV (bt848 rev 18)
   3Com 3c905b-tx-nm
   1 GB 266 DDR
   2 Hard Disk Drives

       ST38410A (8 Gb primary ide controller, master)
       ST34081A (40 Gb primary ide controller, slave)



There are not interrupt sharing

              CPU0
     0:   36350405          XT-PIC  timer
     1:       3199          XT-PIC  keyboard
     2:          0          XT-PIC  cascade
     8:          1          XT-PIC  rtc
     9:      47190          XT-PIC  usb-uhci
    10:      87417          XT-PIC  eth0
    11:    4282929          XT-PIC  nvidia
    12:          3          XT-PIC  PS/2 Mouse
    14:     226511          XT-PIC  ide0
    15:      23866          XT-PIC  ide1
   NMI:          0
   ERR:          0


The Hurd Partition size is
       /dev/hdb2   *      2296      2361    530145   83  Linux




What's I'm doing wrong ??


Best Regards

Gerardo Pirla Diaz