Re: problem saving multiplot to a file

[Manojit Roy]

The way I solve this problem is by creating a load file "load.m", at the
beginning of which is your gset commands, followed by plot commands and
ended with "gset nomulti" (the last command is to get a readable
postscript file). Each time when I need to refresh the plot, I quit
octave, restart it, and execute "load". This complicated method may have
to do with deleting intermediate tmp files (command "purge_tmp_files" does
not do a good job). I am sure there are better ways, maybe someone can
help.

Thanks,
Manojit


On Thu, 12 Jun 2003, Umme Salma wrote:

>
> hi,
> I wanted to save a multiplot in a postscript file .
> but it complains that the output or the terminal cannot be changed in
> the multiplot mode.
> I tried to switch to single plot mode do the setting i.e
> gset term postscript
> gset output "dev.ps"
> and then switched to multiplot and do the plotting but it is not
> plotting to the required file.
> is there a solution for this?
> regards,
> salma
>
> **************************Disclaimer************************************
>
> Information contained in this E-MAIL being proprietary to Wipro Limited is
> 'privileged' and 'confidential' and intended for use only by the individual
>  or entity to which it is addressed. You are notified that any use, copying
> or dissemination of the information contained in the E-MAIL in any manner
> whatsoever is strictly prohibited.
>
> ***************************************************************************
>







-------------------------------------------------------------
Octave is freely available under the terms of the GNU GPL.

Octave's home on the web:  http://www.octave.org
How to fund new projects:  http://www.octave.org/funding.html
Subscription information:  http://www.octave.org/archive.html
-------------------------------------------------------------