[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Octave Installation problem?
|
From: |
Jaroslav Hajek |
|
Subject: |
Re: Octave Installation problem? |
|
Date: |
Wed, 12 Aug 2009 15:22:17 +0200 |
On Wed, Aug 12, 2009 at 3:14 PM, Wooten, Mike R.<address@hidden> wrote:
>
> I just installed Octave version 3.2.2
> I did the configure and make steps and got the message:
>
> Octave successfully built. Now choose from the following:
> ./run-octave - to run in place to test before installing
> make check - to run the tests
> make install - to install
>
> When I run run-octave, I get:
> ./run-octave
> Segmentation fault
>
> I'm installing on a linux system using Fedora 2.6.15 (an older version I
> know)
>
A miscompilation, most likely. Try ./run-octave -g or ./run-octave
-valgrind (if you have gdb/valgrind installed) to check out what
crashes. Also, please share your config.log (it's huge so best use
pastebin or something similar).
regards
--
RNDr. Jaroslav Hajek
computing expert & GNU Octave developer
Aeronautical Research and Test Institute (VZLU)
Prague, Czech Republic
url: www.highegg.matfyz.cz