[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: CueVoice issue fixed

From: Carl Sorensen
Subject: Re: CueVoice issue fixed
Date: Wed, 12 Jan 2011 08:28:56 -0700

On 1/11/11 5:30 PM, "Mike Solomon" <address@hidden> wrote:

> Unfortunately, I cannot automate the clef change stuff because of the way the
> engraver works - unless beams are announced earlier, the engraver can't catch
> them in time.  That means that I'd have to keep every grob alive in case there
> were a beam that extended over the whole duration of the piece through
> auto-beaming and not through explicit signaling (this is admittedly insanely
> unlikely, but it is also exactly the kinda thing I'd do).

Autobeams always end at measure ends.  You can't keep autobeaming alive
through the entire piece, at least at present.



reply via email to

[Prev in Thread] Current Thread [Next in Thread]