I am trying to compile Lilypond 1.5.60. If I run
-----------------------------------------------------------------
% ./configure
(lots of stuff...)
% make all
(other stuff...)
-----------------------------------------------------------------
all goes well, but if I use the command-line switch `--prefix=/usr' with
`configure', I get:
-----------------------------------------------------------------
% ./configure --prefix=/usr
(lots of stuff, the same as above...)
% make all
make/stepmake.make:71: /usr/share/stepmake/stepmake/no-builtin-rules.make:
No such file or directory
make/stepmake.make:82: /usr/share/stepmake/stepmake/generic-vars.make: No
such file or directory
make/stepmake.make:82: /usr/share/stepmake/stepmake/toplevel-vars.make: No
such file or directory
make/stepmake.make:82: /usr/share/stepmake/stepmake/po-vars.make: No such
file or directory
make/stepmake.make:82: /usr/share/stepmake/stepmake/install-vars.make: No
such file or directory
make/substitute.make:4: /usr/share/stepmake/stepmake/substitute-vars.make:
No such file or directory
make/substitute.make:5:
/usr/share/stepmake/stepmake/substitute-rules.make: No such file or
directory
make/stepmake.make:89: /usr/share/stepmake/stepmake/generic-rules.make: No
such file or directory
...
-----------------------------------------------------------------
and so on. By tracing file `config.log' I do not see any error
message. So what's wrong with my configuration? I have Guile 1.4.1.
Maurizio
_______________________________________________
Lilypond-user mailing list
address@hidden
http://mail.gnu.org/mailman/listinfo/lilypond-user